I tried restarting the EasyTouch and SL systems - no fix. It's only the remote access that is problematic. All established timers and buttons work fine. Use the end of a paperclip or another similar device to press the reset button on the protocol adaptor three times within five seconds with approximately second between presses. BTW, the EasyTouch 8 is fully functional. Locate your ScreenLogic2 Protocol Adaptor. I also don't know if it is at all related to the recent rain, as I haven't use the spa in a week or two. IntelliTouch ScreenLogic User’s Guide Pentair: xx-xx-xx Pentair: xx-xx-xx. Click the Configure ScreenLogic button if you want to configure your system via the Configurator utility (see page 32 for more information). I suspect the problem lies in the interface between SL and the EasyTouch 8 system but just guessing. Click the Start ScreenLogic button to connect to your system and start ScreenLogic. I've tried the ScreenLogic on my OSX desktop, as opposed to iOS device, and same thing - it appears to see the pool (no error on connecting) but no commands work. I also get no reading on pool/air temperature. The iOS app loads and establishes a connection with the pool, but pressing buttons to turn the pump, spa, lights, etc on all fail - the app APPEARS to have established the connection but nothing happens pool side. I tried to use SL right after that storm to start up the spa last night and it failed. We here in San Diego had a decent amount of rain for about a 24 hour period. ![]() Been using Pentair's ScreenLogic to control my pool and spa (all Pentair equipment) for almost a year, no problem.
0 Comments
Leave a Reply. |